(PACK of 10) Emergency Lighting Test Unit Kit

It is a mandatory legislative requirement that any building or structure that has an emergency evacuation lighting system installed be regularly inspected and maintained in accordance with the requirements of AS/NZS 2293.2

This standard sets out the periodic inspection and maintenance procedures which are necessary to ensure that the emergency evacuation lighting system will be in a state of readiness for operation at all times and this maintenance & inspection work only be carried out by persons with suitable qualifications and experience.

Unit discharge tests shall be carried out at six monthly intervals by simulating a mains failure. All luminaires and exit signs shall remain illuminated for the full duration of this discharge test. Any luminaire with a battery that cannot sustain illumination for the full duration of the test shall have this battery replaced and when fully charged retested.



  • Control single point systems
  • Manual or automatic reset
  • Simulate supply failure to exit signs in accordance with AS/NZS 2293.2

Technical Data:

Description:        Emergency lighting test switch (enclosed)
Operation:          Rotary selector switch operation
Dimensions:       160 x 122 x 85 (mm)
Operating Voltage: 230V AC ± 5%, 50/60Hz
Cable entry:         4mm²
Contactor:            4 pole, 25A NC
Time Delay:         Fully programmable
Operating Temperature: 5 to 50°C
IP Rating:              IP20


***This product must be installed by a licensed electrician***


Barcode # 9354506003791
Brand 3A AU